Как правельно сбросить памперс этой чертовой машинки?

Для этой модели нужна сервисная утилита, можно сбросить только с её помощью. В свободном доступе её пока нет, так что, только в АСЦ...

спаибо - вод тока сервисных центров в радиусе тысячи км нетю-у-у-у-у!!!

Ну если так всё плохо вводи его при включении в сервисный режим и печатай студенты както принессли IP 1000 чернила просто выплёскивались у них в отпечатаных страницах было 12000 так что всё просто если нет выхода

... тоже вариант :D

Вот официальный ответ от Canon: "Thank you for contacting Canon product support regarding the
availability of an ink level reset. We value you as a Canon customer
and appreciate the opportunity to assist you with your PIXMA iP2600.

The iP2600 does not offer an ink level reset. The Canon Think Tank
System™ uses a combination optical sensor and ink counters to estimate
the amount of ink inside the ink tanks. The optical sensor can only
verify whether ink exists inside the reservoir or not. When the state
of the ink tanks is between 100% and 50% capacity, the ink level status
is determined by the ink counter. The ink counters estimate the amount
of ink left inside each ink tank based on the ink usage and the purge
cycle (the purge cycle refers to whenever the printer is cleaning
itself). When the optical sensor triggers, this means that ink inside
the reservoir portion of the ink tank is empty and the ink level status
should display that 25% of the ink is available. The remaining ink
exists inside the sponges inside the ink tank. The ink counters are
used to estimate the amount of ink inside sponge and then will trigger
an error message when the ink tank is empty. A typical problem that may
occur is if an ink tank is replaced when the ink level status displays
that the level is higher than 25%. Since the optical sensor can only
determine if there is ink inside the reservoir and not the intermediate
ink level, the ink level status never changes because nothing triggers
that the ink tank has been changed. The ink level status will probably
remain at 50% until the ink inside the ink tank reservoir empties, then
the ink level status will display that 25% of the ink left and decrement
the ink counter as normal.

Since the ink level status is maintained inside the printer and not by
driver, uninstalling the driver will not reset the ink counter. If it
is necessary to reset the counter on a specific ink tank, temporarily
place an empty ink tank in place of the desired ink tank counter that
needs to be reset. The ink level status should display that the ink
tank is 25% full. Replace the full ink tank back into the appropriate
slot and the ink level status should display at 100%. An obvious issue
is that if the ink tank placed into the printer is not full, the ink
level status will still indicate that the ink tank is 100% full.

We hope this information is helpful to you. Please let us know if we
can be of any further assistance with your iP2600.

Thank you for choosing Canon.

Sincerely,

Deborah
Technical Support Representative
" Короче это означает - не дёргайтесь, ничего не получится. Там используется и счётчик листов и лазерный уровнемер.
С приветом.
E.